2007-08-02 Joel Sherrill <joel.sherrill@OARcorp.com>

	* Makefile.am, configure.ac, develenv/direct.t: Remove RDBG.
	* rgdb_specs/.cvsignore, rgdb_specs/Makefile.am, rgdb_specs/comm.t,
	rgdb_specs/conclusion.t, rgdb_specs/daemon.t,
	rgdb_specs/gdbinternals.t, rgdb_specs/interfacing.t,
	rgdb_specs/intro.t, rgdb_specs/layers.eps, rgdb_specs/layers.jpg,
	rgdb_specs/layers.txt, rgdb_specs/objectives.t,
	rgdb_specs/process.eps, rgdb_specs/process.jpg,
	rgdb_specs/process.txt, rgdb_specs/revision.t,
	rgdb_specs/rgdb_specs.texi, rgdb_specs/seqbreak.eps,
	rgdb_specs/seqbreak.jpg, rgdb_specs/seqbreak.txt,
	rgdb_specs/seqdetach.eps, rgdb_specs/seqdetach.jpg,
	rgdb_specs/seqdetach.txt, rgdb_specs/seqinit.eps,
	rgdb_specs/seqinit.jpg, rgdb_specs/seqinit.txt, rtems_gdb/.cvsignore,
	rtems_gdb/Makefile.am, rtems_gdb/commands.t, rtems_gdb/example.t,
	rtems_gdb/intro.t, rtems_gdb/rtems_gdb.texi, rtems_gdb/started.t,
	rtems_gdb/swarch.t, rtems_gdb/trouble.t: Removed.

1 files changed, 0 insertions, 53 deletions

diff --git a/doc/rtems_gdb/started.t b/doc/rtems_gdb/started.t
deleted file mode 100644
index c8b4bad3e9..0000000000
--- a/doc/rtems_gdb/started.t
+++ /dev/null
@@ -1,53 +0,0 @@
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-
-@chapter Getting Started
-
-This section describes the steps which are necessary to set up a
-debugging session with RTEMS/GDB.
-
-
-@section Compiling The System Components
-
-The components that need to be debugged have to be compiled with the -g option
-in order the generated file to contain the required information for the debug
-session.
-
-
-@section Starting a debugging session
-
-After having launched GDB, the user must connect to the RTEMS target with the
-following commands:
-
-@example
-(gdb) setrpcmode sun
-(gdb) setdaemontype rdbg
-(gdb) target rtems target-name
-@end example
-
-Then he can use the file GDB command to specify the binary to be debugged.
-
-This initialization phase can be written in a @code{``.gdbinit''}
-file. Each time, the user will launch GDB, it will execute this initialization
-sequence.
-
-
-@section Attaching To The System
-
-The entire target system is viewed as a single multi-threaded process,
-the identifier of which is 1. To attach, use:
-
-@example
-(gdb) attach 1
-@end example
-
-When successfully attached, the user can control the execution of
-the target system from the debugger.
-
-