From 00de6acc8cf39313d6f2a0858955f3a2afcb67c0 Mon Sep 17 00:00:00 2001 From: Joel Sherrill Date: Thu, 2 Aug 2007 14:59:16 +0000 Subject: 2007-08-02 Joel Sherrill * Makefile.am, configure.ac, develenv/direct.t: Remove RDBG. * rgdb_specs/.cvsignore, rgdb_specs/Makefile.am, rgdb_specs/comm.t, rgdb_specs/conclusion.t, rgdb_specs/daemon.t, rgdb_specs/gdbinternals.t, rgdb_specs/interfacing.t, rgdb_specs/intro.t, rgdb_specs/layers.eps, rgdb_specs/layers.jpg, rgdb_specs/layers.txt, rgdb_specs/objectives.t, rgdb_specs/process.eps, rgdb_specs/process.jpg, rgdb_specs/process.txt, rgdb_specs/revision.t, rgdb_specs/rgdb_specs.texi, rgdb_specs/seqbreak.eps, rgdb_specs/seqbreak.jpg, rgdb_specs/seqbreak.txt, rgdb_specs/seqdetach.eps, rgdb_specs/seqdetach.jpg, rgdb_specs/seqdetach.txt, rgdb_specs/seqinit.eps, rgdb_specs/seqinit.jpg, rgdb_specs/seqinit.txt, rtems_gdb/.cvsignore, rtems_gdb/Makefile.am, rtems_gdb/commands.t, rtems_gdb/example.t, rtems_gdb/intro.t, rtems_gdb/rtems_gdb.texi, rtems_gdb/started.t, rtems_gdb/swarch.t, rtems_gdb/trouble.t: Removed. --- doc/rtems_gdb/started.t | 53 ------------------------------------------------- 1 file changed, 53 deletions(-) delete mode 100644 doc/rtems_gdb/started.t (limited to 'doc/rtems_gdb/started.t') diff --git a/doc/rtems_gdb/started.t b/doc/rtems_gdb/started.t deleted file mode 100644 index c8b4bad3e9..0000000000 --- a/doc/rtems_gdb/started.t +++ /dev/null @@ -1,53 +0,0 @@ -@c -@c COPYRIGHT (c) 1988-2002. -@c On-Line Applications Research Corporation (OAR). -@c All rights reserved. -@c -@c $Id$ -@c - - -@chapter Getting Started - -This section describes the steps which are necessary to set up a -debugging session with RTEMS/GDB. - - -@section Compiling The System Components - -The components that need to be debugged have to be compiled with the -g option -in order the generated file to contain the required information for the debug -session. - - -@section Starting a debugging session - -After having launched GDB, the user must connect to the RTEMS target with the -following commands: - -@example -(gdb) setrpcmode sun -(gdb) setdaemontype rdbg -(gdb) target rtems target-name -@end example - -Then he can use the file GDB command to specify the binary to be debugged. - -This initialization phase can be written in a @code{``.gdbinit''} -file. Each time, the user will launch GDB, it will execute this initialization -sequence. - - -@section Attaching To The System - -The entire target system is viewed as a single multi-threaded process, -the identifier of which is 1. To attach, use: - -@example -(gdb) attach 1 -@end example - -When successfully attached, the user can control the execution of -the target system from the debugger. - - -- cgit v1.2.3