1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
|
/* include/bspopts.h.in. Generated from configure.ac by autoheader. */
/* enables the data cache, if defined to a value other than zero */
#undef BSP_DATA_CACHE_ENABLED
/* If defined, then the BSP Framework will put a non-zero pattern into the
RTEMS Workspace and C program heap. This should assist in finding code that
assumes memory starts set to zero. */
#undef BSP_DIRTY_MEMORY
/* enables the instruction cache, if defined to a value other than zero */
#undef BSP_INSTRUCTION_CACHE_ENABLED
/* If defined, print a message and wait until pressed before resetting board
when application exits. */
#undef BSP_PRESS_KEY_FOR_RESET
/* If defined, reset the board when the application exits. */
#undef BSP_RESET_BOARD_AT_EXIT
/* (BSP--console driver) Must be defined to be one of SMC1_MINOR, SMC2_MINOR,
SCC2_MINOR, SCC3_MINOR, or SCC4_MINOR. Determines which device will be
registered as /dev/console. */
#undef CONSOLE_MINOR
/* used by irq/irq.c */
#undef DISPATCH_HANDLER_STAT
/* Define to the address where bug reports for this package should be sent. */
#undef PACKAGE_BUGREPORT
/* Define to the full name of this package. */
#undef PACKAGE_NAME
/* Define to the full name and version of this package. */
#undef PACKAGE_STRING
/* Define to the one symbol short name of this package. */
#undef PACKAGE_TARNAME
/* Define to the home page for this package. */
#undef PACKAGE_URL
/* Define to the version of this package. */
#undef PACKAGE_VERSION
/* (BSP--console driver) Must be defined to be one of SMC1_MINOR, SMC2_MINOR,
SCC2_MINOR, SCC3_MINOR, or SCC4_MINOR. Determines which device is used for
output by printk(). If the port that printk() uses is also used for other
I/O (e.g. if PRINTK_MINOR == \$CONSOLE_MINOR), then both ports should use
the same type of I/O, otherwise the drivers will likely conflict with each
other. */
#undef PRINTK_MINOR
/* (BSP--console driver) Define to 0 or 1 if you want polled I/O performed by
RTEMS. Define to 1 if you want interrupt-driven performed by RTEMS. Define
to 2 if you want polled I/O performed by EPPCBug. There is no provision to
have a mix of interrupt-driven and polled I/O ports, except that the printk
port may use a different mode from the other ports. If this is done, do not
open the printk port from an RTEMS application. With EPPCBug 1.1, if mode 2
is selected, CONSOLE_MINOR must be set to SMC1_MINOR. This is a deficiency
of the firmware: it does not perform serial I/O on any port other than its
default debug port, which must be SMC1. */
#undef UARTS_IO_MODE
/* Define to 1 if you want termios support for every port. Termios support is
independent of the choice of UART I/O mode. */
#undef UARTS_USE_TERMIOS
|