diff options
Diffstat (limited to 'c/src/tests/libtests/termios/README')
-rw-r--r-- | c/src/tests/libtests/termios/README | 99 |
1 files changed, 0 insertions, 99 deletions
diff --git a/c/src/tests/libtests/termios/README b/c/src/tests/libtests/termios/README deleted file mode 100644 index 2515b2994f..0000000000 --- a/c/src/tests/libtests/termios/README +++ /dev/null @@ -1,99 +0,0 @@ -# -# $Id$ -# - -These tests are brought to you by the letter `q'. - -When you start the test, you should see: - - You have the following choices: - 1 - Reset the struct termios - 2 - Look at the current termios setting - 3 - Change the line characteristics - 4 - Test canonical input - 5 - Test raw input - 9 - Exit - Enter your choice (1 to 5 or 9, followed by a carriage return): - -The individual tests are briefly described below: - - -1. Reset the struct termios. - -Included just in case you get into trouble. More than likely, if you are in -trouble, neither input nor output are likely to work and this won't help. But -hey, it should give you some warm fuzzy feeling that its there... - - -2. Look at the current termios setting - -Dumps the current state of the termios settings in hex and with symbolic flag -names. - - -3. Change the line characteristics - -Allows you to change the line speed, parity, number of data bits and number of -stop bits. You must supply a delay before the change takes effect. This gives -you time to switch your terminal settings to continue with the test. - -WARNING: Minicom under Linux gets extremely unhappy (as does the /dev/ttyS? -underlying devices) if you change the line characteristics and do not make the -corresponding change in the terminal emulator. - - -4. Test canonical input - -Simple test of canonical or cooked input mode. Try typing some tabs and/or control characters and make sure that you can backspace over them properly. - - -5. Test raw input - -The line is placed into raw mode and four separate test are done: - -VMIN=0, VTIME=0 - Each letter you type should produce a line of output. - The `count' should be quite large, since (as you correctly - pointed out) the read is non-blocking. The time should be - the interval between typing characters. - Type a `q' to finish the test. -VMIN=0, VTIME=20 - Again, each letter should produce a line of output. The - `count' should be much smaller -- the read is non-blocking - but has a timeout of 2 seconds, so the count should be about - half the `interval'. - Type a `q' to finish the test. -VMIN=5, VTIME=0 - A line should be produced for every 5 characters typed. The - count should be 1. This is a blocking read. - Type a `q' as the first character of a group of 5 to finish - the test. -VMIN=5, VTIME=20 - Type a character. Two seconds later a line should be printed. - Count should be 1. Type a character, and another within 2 seconds. - Two seconds after last character (or right after the 5th character) - a line should be printed. - Type a `q' as the first character of a group to finish the test. - - -9. Exit - -Gets you out of the test. - - -Clear??? - - ---- -Eric Norum -eric@skatter.usask.ca -Saskatchewan Accelerator Laboratory -University of Saskatchewan -Saskatoon, Canada. - -Charles-Antoine Gauthier -Software Engineering Group -Institute for Information Technology -National Research Council of Canada -charles.gauthier@nrc.ca - |