diff options
Diffstat (limited to 'c/src/lib/libbsp/powerpc/ep1a/include/bsp.h')
-rw-r--r-- | c/src/lib/libbsp/powerpc/ep1a/include/bsp.h | 209 |
1 files changed, 209 insertions, 0 deletions
diff --git a/c/src/lib/libbsp/powerpc/ep1a/include/bsp.h b/c/src/lib/libbsp/powerpc/ep1a/include/bsp.h new file mode 100644 index 0000000000..8c13a506d7 --- /dev/null +++ b/c/src/lib/libbsp/powerpc/ep1a/include/bsp.h @@ -0,0 +1,209 @@ +/* + * + * COPYRIGHT (c) 1989-1999. + * On-Line Applications Research Corporation (OAR). + * + * The license and distribution terms for this file may be + * found in the file LICENSE in this distribution or at + * http://www.rtems.com/license/LICENSE. + * + * $Id$ + */ + +#ifndef EP1A_BSP_H +#define EP1A_BSP_H + +#include <bspopts.h> + +#include <rtems.h> +#include <rtems/console.h> +#include <libcpu/io.h> +#include <rtems/clockdrv.h> +#include <bsp/vectors.h> + + +/* + * confdefs.h overrides for this BSP: + * - termios serial ports (defaults to 1) + * - Interrupt stack space is not minimum if defined. + */ + +#define CONFIGURE_NUMBER_OF_TERMIOS_PORTS 2 +#define CONFIGURE_INTERRUPT_STACK_MEMORY (16 * 1024) + +/* fundamental addresses for BSP (CHRPxxx and PREPxxx are from libcpu/io.h) */ +#define _IO_BASE CHRP_ISA_IO_BASE +#define _ISA_MEM_BASE CHRP_ISA_MEM_BASE +/* address of our ram on the PCI bus */ +#define PCI_DRAM_OFFSET CHRP_PCI_DRAM_OFFSET +#define PCI_MEM_BASE 0x80000000 +#define PCI_MEM_BASE_ADJUSTMENT 0 + +/* address of our ram on the PCI bus */ +#define PCI_DRAM_OFFSET CHRP_PCI_DRAM_OFFSET + +/* offset of pci memory as seen from the CPU */ +#define PCI_MEM_BASE 0x00000000 + +/* Override the default values for the following DEFAULT */ +#define PCI_CONFIG_ADDR 0xfec00000 /* 0xcf8 */ +#define PCI_CONFIG_DATA 0xfee00000 /* 0xcfc */ + +/* + * EP1A configuration Registers. + * Note: All addresses assume flash boot. + */ + +#define EQUIPMENT_PRESENT_REGISTER1 ((volatile unsigned char *)0xffa00000) +#define EQUIPMENT_PRESENT_REGISTER2 ((volatile unsigned char *)0xffa00008) +#define BOARD_REVISION_REGISTER1 ((volatile unsigned char *)0xffa00010) +#define BOARD_REVISION_REGISTER2 ((volatile unsigned char *)0xffa00018) +#define GENERAL_REGISTER1 ((volatile unsigned char *)0xffa00020) +#define GENERAL_REGISTER2 ((volatile unsigned char *)0xffa00028) +#define WATCHDOG_TRIGGER ((volatile unsigned char *)0xffa00030) + +/* EQUIPMENT_PRESENT_REGISTER1 */ +#define BANK_MEMORY_SIZE_128MB 0x20 +#define BANK_MEMORY_SIZE_64MB 0x10 +#define ECC_ENABLED 0x04 + +/* EQUIPMENT-PRESENT_REGISTER2 */ +#define PLL_CFG_MASK 0xf8 +#define MHZ_33_66_200 0x70 /* PCI MEM CPU Frequency */ +#define MHZ_33_100_200 0x80 /* PCI MEM CPU Frequency */ +#define MHZ_33_66_266 0xb0 /* PCI MEM CPU Frequency */ +#define MHZ_33_66_333 0x50 /* PCI MEM CPU Frequency */ +#define MHZ_33_100_333 0x08 /* PCI MEM CPU Frequency */ +#define MHZ_33_100_350 0x78 /* PCI MEM CPU Frequency */ + +#define PMC_SLOT1_PRESENT 0x02 +#define PMC_SLOT2_PRESENT 0x01 + +/* BOARD_REVISION_REGISTER1 */ +#define ARTWORK_REVISION_MASK 0xf0 +#define BUILD_REVISION_MASK 0x0f + +/* BOARD_REVISION_REGISTER2 */ +#define HARDWARE_ID_MASK 0xe0 +#define HARDWARE_ID_PPC5_EP1A 0xe0 +#define HARDWARE_ID_EP1B 0xc0 + +/* GENERAL_REGISTER1 */ +#define DISABLE_WATCHDOG 0x80 +#define DISABLE_RESET_SWITCH 0x40 +#define DISABLE_USER_FLASH 0x20 +#define DISABLE_BOOT_FLASH 0x10 +#define LED4_OFF 0x08 +#define LED3_OFF 0x04 +#define LED2_OFF 0x02 +#define LED1_OFF 0x01 + + +/* GENERAL_REGISTER2 */ +#define BSP_FLASH_VPP_ENABLE 0x01 +#define BSP_FLASH_PAGE_MASK 0x38 +#define BSP_FLASH_PAGE_SHIFT 0x03 +#define BSP_BIT_SLOWSTART 0x04 +#define BSP_OFFLINE 0x02 +#define BSP_SYSFAIL 0x01 + +/* WATCHDOG_TRIGGER */ +#define BSP_FLASH_BASE 0xff000000 +#define BSP_VME_A16_BASE 0x9fff0000 +#define BSP_VME_A24_BASE 0x9f000000 + +/* + * address definitions for several devices + * + */ +#define UART_OFFSET_1_8245 (0x04500) +#define UART_OFFSET_2_8245 (0x04600) +#define UART_BASE_COM1 0xff800000 +#define UART_BASE_COM2 0xff800040 + +#include <bsp/openpic.h> + +/* Note docs list 0x41000 but OpenPIC has a 0x1000 pad at the start + * assume that open pic specifies this pad but not mentioned in + * 8245 docs. + * This is an offset from EUMBBAR + */ +#define BSP_OPEN_PIC_BASE_OFFSET 0x40000 +#define BSP_PIC_DO_EOI openpic_eoi(0) + + +#ifndef ASM +#define outport_byte(port,value) outb(value,port) +#define outport_word(port,value) outw(value,port) +#define outport_long(port,value) outl(value,port) + +#define inport_byte(port,value) (value = inb(port)) +#define inport_word(port,value) (value = inw(port)) +#define inport_long(port,value) (value = inl(port)) + +/* + * EUMMBAR + */ +extern unsigned int EUMBBAR; + +/* + * Total memory + */ +extern unsigned int BSP_mem_size; + +/* + * PCI Bus Frequency + */ +extern unsigned int BSP_bus_frequency; + +/* + * processor clock frequency + */ +extern unsigned int BSP_processor_frequency; + +/* + * Time base divisior (how many tick for 1 second). + */ +extern unsigned int BSP_time_base_divisor; + +#define BSP_Convert_decrementer( _value ) \ + ((unsigned long long) ((((unsigned long long)BSP_time_base_divisor) * 1000000ULL) /((unsigned long long) BSP_bus_frequency)) * ((unsigned long long) (_value))) + +#define Processor_Synchronize() \ + asm(" eieio ") + +extern rtems_configuration_table BSP_Configuration; +extern void BSP_panic(char *s); +extern void rtemsReboot(void); +extern int BSP_disconnect_clock_handler (void); +extern int BSP_connect_clock_handler (void); + +/* + * FLASH + */ +int BSP_FLASH_Enable_writes( rtems_unsigned32 area ); +int BSP_FLASH_Disable_writes( rtems_unsigned32 area ); +void BSP_FLASH_set_page( rtems_unsigned8 page ); + +#define BSP_FLASH_ENABLE_WRITES( _area) BSP_FLASH_Enable_writes( _area ) +#define BSP_FLASH_DISABLE_WRITES(_area) BSP_FLASH_Disable_writes( _area ) +#define BSP_FLASH_SET_PAGE(_page) BSP_FLASH_set_page( _page ) + + +/* clear hostbridge errors + * + * enableMCP: whether to enable MCP checkstop / machine check interrupts + * on the hostbridge and in HID0. + * + * NOTE: HID0 and MEREN are left alone if this flag is 0 + * + * quiet : be silent + * + * RETURNS : raven MERST register contents (lowermost 16 bits), 0 if + * there were no errors + */ +extern unsigned long _BSP_clear_hostbridge_errors(int enableMCP, int quiet); + +#endif + +#endif |