diff options
Diffstat (limited to 'c/src/lib/libbsp/arm/lpc24xx/README')
| -rw-r--r-- | c/src/lib/libbsp/arm/lpc24xx/README | 32 |
1 files changed, 32 insertions, 0 deletions
diff --git a/c/src/lib/libbsp/arm/lpc24xx/README b/c/src/lib/libbsp/arm/lpc24xx/README index 1f58b9dfd4..6a98e5996f 100644 --- a/c/src/lib/libbsp/arm/lpc24xx/README +++ b/c/src/lib/libbsp/arm/lpc24xx/README @@ -7,7 +7,39 @@ Development Board: QVGA Base Board from Embedded Artists http://www.embeddedartists.com/products/uclinux/oem_lpc2478.php Drivers: + o Console o Clock o RTC o SSP (SPI mode): This driver is in active development. Use with care. + o Network + +Howto setup QVGA Base Board? + + o Unpack board. + o Connect board via USB to your PC. + o Verify that demo application runs. + o Disconnect board. + o Change jumpers to enable ISP. + o Connect board. + o Load U-Boot image 'u-boot_v1.1.6_lpc2468oem_v1_8_16bit.hex' + (available from the EA support page) into the flash (flash tool + FlashMagic is availabe from NXP). + o Change jumbers back to disable ISP. + o Use a terminal program to change the U-Boot settings via the console. + o U-Boot settings: + set ethaddr '00:1a:f1:X:X:X' + set serverip 'X.X.X.X' + set ipaddr 'X.X.X.X' + set rtems 'tftp a1000000 lpc2478.img;bootm' + set bootcmd 'echo Booting RTEMS ...;run rtems' + saveenv + +Application Board: NCS (Nurse Control Station) + + Board: NextGenNCS + Processor: NXP LPC2478 + SDRAM: 8MByte, 16 bit wide + Ext. Flash: 1MByte, 16 bit wide + Console: UART, 115200 Baud + Network: 100Base-T |