2007-12-04 Joel Sherrill <joel.sherrill@OARcorp.com>

	* cpu_supplement/arm.t, cpu_supplement/i386.t, cpu_supplement/m68k.t,
	cpu_supplement/mips.t, cpu_supplement/powerpc.t, cpu_supplement/sh.t,
	cpu_supplement/sparc.t, cpu_supplement/tic4x.t, porting/cpuinit.t,
	user/conf.t, user/init.t: Move interrupt_stack_size field from CPU
	Table to Configuration Table. Eliminate CPU Table from all ports.
	Delete references to CPU Table in all forms.

8 files changed, 0 insertions, 339 deletions

diff --git a/doc/cpu_supplement/arm.t b/doc/cpu_supplement/arm.t
index 757b70fbf6..95fd5029e6 100644
--- a/doc/cpu_supplement/arm.t
+++ b/doc/cpu_supplement/arm.t
@@ -485,45 +485,3 @@ install an interrupt stack and -- for whatever reason -- an
 interrupt occurs before initialize_executive is invoked, then
 the results are unpredictable.
 
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The XXX version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the XXX.  This
-information is provided to allow RTEMS to interoperate
-effectively with the BSP.  The C structure definition is given
-here:
-
-@example
-@group
-typedef struct @{
-  uint32_t     interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code 
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/i386.t b/doc/cpu_supplement/i386.t
index 3ca07b3405..81222a0f6e 100644
--- a/doc/cpu_supplement/i386.t
+++ b/doc/cpu_supplement/i386.t
@@ -574,45 +574,3 @@ requirements:
 For more information regarding the i386s data structures and their
 contents, refer to Intel's 386 Programmer's Reference Manual.
 
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The i386 version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the i386.  This information
-is provided to allow RTEMS to interoperate effectively with the
-BSP.  The C structure definition is given here:
-
-@example
-@group
-typedef struct @{
-  uint32_t     interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/m68k.t b/doc/cpu_supplement/m68k.t
index c3c014dd1a..b39c3236b3 100644
--- a/doc/cpu_supplement/m68k.t
+++ b/doc/cpu_supplement/m68k.t
@@ -662,47 +662,3 @@ automatically as part of initialization.  If the BSP does not
 install an interrupt stack and -- for whatever reason -- an
 interrupt occurs before initialize_executive is invoked, then
 the results are unpredictable.
-
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The MC68xxx version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the MC68xxx.  This
-information is provided to allow RTEMS to interoperate
-effectively with the BSP.  The C structure definition is given
-here:
-
-@example
-@group
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/mips.t b/doc/cpu_supplement/mips.t
index 385acb592b..1d65981719 100644
--- a/doc/cpu_supplement/mips.t
+++ b/doc/cpu_supplement/mips.t
@@ -566,47 +566,3 @@ automatically as part of initialization.  If the BSP does not
 install an interrupt stack and -- for whatever reason -- an
 interrupt occurs before initialize_executive is invoked, then
 the results are unpredictable.
-
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The XXX version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the XXX.  This
-information is provided to allow RTEMS to interoperate
-effectively with the BSP.  The C structure definition is given
-here:
-
-@example
-@group
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/powerpc.t b/doc/cpu_supplement/powerpc.t
index d8073e3ccf..8b6604acb7 100644
--- a/doc/cpu_supplement/powerpc.t
+++ b/doc/cpu_supplement/powerpc.t
@@ -886,41 +886,3 @@ conditions can be properly handled.
 handlers.
 
 @end itemize
-
-@c
-@c  COPYRIGHT (c) 1989-2007.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The PowerPC version of the RTEMS CPU Dependent
-Information Table is given by the C structure definition is
-shown below:
-
-@example
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS allocated interrupt stack in bytes.
-This value must be at least as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/sh.t b/doc/cpu_supplement/sh.t
index 252c44787c..42b9c24a63 100644
--- a/doc/cpu_supplement/sh.t
+++ b/doc/cpu_supplement/sh.t
@@ -574,47 +574,3 @@ automatically as part of initialization.  If the BSP does not
 install an interrupt stack and -- for whatever reason -- an
 interrupt occurs before initialize_executive is invoked, then
 the results are unpredictable.
-
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The XXX version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the XXX.  This
-information is provided to allow RTEMS to interoperate
-effectively with the BSP.  The C structure definition is given
-here:
-
-@example
-@group
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table
diff --git a/doc/cpu_supplement/sparc.t b/doc/cpu_supplement/sparc.t
index 844fa9933e..7cfb45ecc3 100644
--- a/doc/cpu_supplement/sparc.t
+++ b/doc/cpu_supplement/sparc.t
@@ -1023,44 +1023,3 @@ conditions can be properly handled.
 least trap handlers for register window overflow and register
 window underflow.
 @end itemize
-
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The SPARC version of the RTEMS CPU Dependent
-Information Table is given by the C structure definition is
-shown below:
-
-@example
-@group
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS allocated interrupt stack in bytes.
-This value must be at least as large as MINIMUM_STACK_SIZE.
-
-@end table
-
diff --git a/doc/cpu_supplement/tic4x.t b/doc/cpu_supplement/tic4x.t
index 98bdfa28c5..ad6cb22312 100644
--- a/doc/cpu_supplement/tic4x.t
+++ b/doc/cpu_supplement/tic4x.t
@@ -777,47 +777,3 @@ automatically as part of initialization.  If the BSP does not
 install an interrupt stack and -- for whatever reason -- an
 interrupt occurs before initialize_executive is invoked, then
 the results are unpredictable.
-
-@c
-@c  COPYRIGHT (c) 1988-1999.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@section Processor Dependent Information Table
-
-
-Any highly processor dependent information required
-to describe a processor to RTEMS is provided in the CPU
-Dependent Information Table.  This table is not required for all
-processors supported by RTEMS.  This chapter describes the
-contents, if any, for a particular processor type.
-
-@subsection CPU Dependent Information Table
-
-The XXX version of the RTEMS CPU Dependent
-Information Table contains the information required to interface
-a Board Support Package and RTEMS on the XXX.  This
-information is provided to allow RTEMS to interoperate
-effectively with the BSP.  The C structure definition is given
-here:
-
-@example
-@group
-typedef struct @{
-  unsigned32   interrupt_stack_size;
-  /* end of fields required on all CPUs */
-@} rtems_cpu_table;
-@end group
-@end example
-
-@table @code
-
-@item interrupt_stack_size
-is the size of the RTEMS
-allocated interrupt stack in bytes.  This value must be at least
-as large as MINIMUM_STACK_SIZE.
-
-@end table