blob: 4364dac5d52d51194774e3c2a8ffe8bb31530851 (
plain) (
tree)
|
|
#
# $Id$
#
Configuration Table Use
=======================
pDeviceFlow
This field is ignored as hardware flow control is not currently supported.
ulCtrlPort1
This field is the base address of the entire DUART.
ulCtrlPort2
This field is the base address of the port specific registers.
ulDataPort
This field is bit mapped as follows:
bit 0: 0 or 1 to indicate the A or B port on the DUART.
bit 1: baud rate set a or b
Note: If both ports on single DUART are not configured for the same
baud rate set, then unexpected results will occur.
getRegister
setRegister
These follow standard conventions.
getData
setData
These are unused since the TX and RX data registers can be accessed
as regular registers.
|