blob: 90177de1f631cfe737c33a4c38fff4e5665a4659 (
plain) (
tree)
|
|
/*
* This include file definitions related to an Intel i386ex board.
*
* COPYRIGHT (c) 1989-1999.
* On-Line Applications Research Corporation (OAR).
*
* The license and distribution terms for this file may be
* found in the file LICENSE in this distribution or at
* http://www.OARcorp.com/rtems/license.html.
*
* $Id$
*/
#ifndef __TS386_h
#define __TS386_h
#ifdef __cplusplus
extern "C" {
#endif
#include <rtems.h>
#include <iosupp.h>
#include <console.h>
#include <clockdrv.h>
#include <bspIo.h>
#include <irq.h>
/*
* Network driver configuration
*/
struct rtems_bsdnet_ifconfig;
extern int rtems_ne_driver_attach (struct rtems_bsdnet_ifconfig *config);
extern void Wait_X_ms (unsigned);
#define RTEMS_BSP_NETWORK_DRIVER_NAME "ne1"
#define RTEMS_BSP_NETWORK_DRIVER_ATTACH rtems_ne_driver_attach
#define NE2000_BYTE_TRANSFERS
/*
* Constants relating to the 8254 (or 8253) programmable interval timers.
*/
#define TIMER_CONFIG 0xF834
#define IO_TIMER1 0xF040
/* Port address of the control port and timer channels */
#define TIMER_CNTR0 (IO_TIMER1 + 0) /* timer 0 counter port */
#define TIMER_CNTR1 (IO_TIMER1 + 1) /* timer 1 counter port */
#define TIMER_CNTR2 (IO_TIMER1 + 2) /* timer 2 counter port */
#define TIMER_MODE (IO_TIMER1 + 3) /* timer mode port */
#define TIMER_SEL0 0x00 /* select counter 0 */
#define TIMER_SEL1 0x40 /* select counter 1 */
#define TIMER_SEL2 0x80 /* select counter 2 */
#define TIMER_INTTC 0x00 /* mode 0, intr on terminal cnt */
#define TIMER_ONESHOT 0x02 /* mode 1, one shot */
#define TIMER_RATEGEN 0x04 /* mode 2, rate generator */
#define TIMER_SQWAVE 0x06 /* mode 3, square wave */
#define TIMER_SWSTROBE 0x08 /* mode 4, s/w triggered strobe */
#define TIMER_HWSTROBE 0x0a /* mode 5, h/w triggered strobe */
#define TIMER_LATCH 0x00 /* latch counter for reading */
#define TIMER_LSB 0x10 /* r/w counter LSB */
#define TIMER_MSB 0x20 /* r/w counter MSB */
#define TIMER_16BIT 0x30 /* r/w counter 16 bits, LSB first */
#define TIMER_BCD 0x01 /* count in BCD */
/*
* Define the time limits for RTEMS Test Suite test durations.
* Long test and short test duration limits are provided. These
* values are in seconds and need to be converted to ticks for the
* application.
*
*/
#define MAX_LONG_TEST_DURATION 300 /* 5 minutes = 300 seconds */
#define MAX_SHORT_TEST_DURATION 3 /* 3 seconds */
/*
* Define the interrupt mechanism for Time Test 27
*
* NOTE: Use a software interrupt for the i386.
*/
#define MUST_WAIT_FOR_INTERRUTPT 0
#define Install_tm27_vector(handler) \
{ \
rtems_isr_entry dummy; \
rtems_interrupt_catch(handler, 0x90, &dummy); \
}
#define Cause_tm27_intr() asm volatile( "int $0x90" : : );
#define Clear_tm27_intr()
#define Lower_tm27_intr()
/*
* Simple spin delay in microsecond units for device drivers.
* This is very dependent on the clock speed of the target.
*/
#define delay( _microseconds ) \
{ \
rtems_unsigned32 _counter; \
\
_counter = (_microseconds); \
\
asm volatile ( "0: nop;" \
" mov %0,%0 ;" \
" loop 0b" : "=c" (_counter) \
: "0" (_counter) \
); \
\
}
/* Constants */
#define RAM_START 0
/* replaced the earlier EI kludge of 0xfffff */
#define RAM_END 0x200000
/* I/O addressing */
/*
*#define Is_tx_ready( _status ) ( (_status) & 0x20 )
*/
/* dec 20. try the TE instead of TBE as the check */
#define Is_tx_ready( _status ) ( (_status) & 0x40 )
#define Is_rx_ready( _status ) ( (_status) & 0x01 )
/* Structures */
#ifdef F386_INIT
#undef BSP_EXTERN
#define BSP_EXTERN
#else
#undef BSP_EXTERN
#define BSP_EXTERN extern
#endif
/*
* Device Driver Table Entries
*/
/*
* NOTE: Use the standard Console driver entry
*/
/*
* NOTE: Use the standard Clock driver entry
*/
/* miscellaneous stuff assumed to exist */
extern rtems_configuration_table BSP_Configuration;
#define IDT_SIZE 256
#define GDT_SIZE 3
extern interrupt_gate_descriptor Interrupt_descriptor_table[IDT_SIZE];
extern segment_descriptors Global_descriptor_table [GDT_SIZE];
BSP_EXTERN unsigned short Idt[3]; /* Interrupt Descriptor Table Address */
BSP_EXTERN unsigned short Gdt[3]; /* Global Descriptor Table Address */
BSP_EXTERN unsigned int Idt_base;
BSP_EXTERN unsigned int Gdt_base;
/* routines */
#ifdef __cplusplus
}
#endif
#endif
/* end of include file */
|