@c @c COPYRIGHT (c) 1988-1998. @c On-Line Applications Research Corporation (OAR). @c All rights reserved. @c @c $Id$ @c @chapter Building the Sample Application @section Unpack the Sample Application Use the following command to unarchive the sample application: @example cd tools tar xzf ../archive/hello_world_ada.tgz @end example @section Create a BSP Specific Makefile Provided are example Makefiles for multiple BSPs. Copy one of these to the file Makefile. and edit it as appropriate for your local configuration. Use the and specified when configuring and installing RTEMS. @section Build the Sample Application Use the following command to start the build of the sample application: @example cd tools/hello_world_ada gmake -f Makefile. @end example If the BSP specific modifications to the Makefile were correct and no errors are detected during the sample application build, it is reasonable to assume that the build of the GNAT/RTEMS Cross Compiler Tools for RTEMS and RTEMS itself for the selected host and target combination was done properly. @section Application Executable If the sample application has successfully been build, then the application executable is placed in the following directory: @example tools/hello_world_ada/o-/.exe @end example How this executable is downloaded to the target board is very dependent on the BOARD_SUPPORT_PACKAGE selected.