/* include/bspopts.h.in.  Generated from configure.ac by autoheader.  */

/* If defined, then the BSP Framework will put a non-zero pattern into the
   RTEMS Workspace and C program heap. This should assist in finding code that
   assumes memory starts set to zero. */
#undef BSP_DIRTY_MEMORY

/* If defined, print a message and wait until pressed before resetting board
   when application exits. */
#undef BSP_PRESS_KEY_FOR_RESET

/* If defined, reset the board when the application exits. */
#undef BSP_RESET_BOARD_AT_EXIT

/* Must be defined to be one of SCI1_MINOR or SCI2_MINOR. Determines which
   device will be registered as /dev/console. */
#undef CONSOLE_MINOR

/* Define to the address where bug reports for this package should be sent. */
#undef PACKAGE_BUGREPORT

/* Define to the full name of this package. */
#undef PACKAGE_NAME

/* Define to the full name and version of this package. */
#undef PACKAGE_STRING

/* Define to the one symbol short name of this package. */
#undef PACKAGE_TARNAME

/* Define to the home page for this package. */
#undef PACKAGE_URL

/* Define to the version of this package. */
#undef PACKAGE_VERSION

/* Must be defined to be one of SCI1_MINOR or SCI2_MINOR. Determines which
   device is used for output by printk(). The printk port always uses polled
   I/O. Don't open the printk port from RTEMS unless also using polled I/O for
   the SCI ports. */
#undef PRINTK_MINOR

/* Define to 1 if you want interrupt-driven I/O for the SCI ports. */
#undef UARTS_IO_MODE

/* Define to 1 if you want termios support for every port. Termios support is
   independent of the choice of UART I/O mode. */
#undef UARTS_USE_TERMIOS

/* Define to the desired timeout (in steps of 1/20 msec) to enable the
   watchdog. Default is to disable the watchdog entirely. */
#undef WATCHDOG_TIMEOUT