| Commit message (Collapse) | Author | Files | Lines |
|---|
|
being set to 0 to indicate that there should be no Clock Tick. This
was used by the Timing Tests to avoid clock tick overhead perturbing
execution times. Now the Timing Tests simply leave the Clock Tick
Driver out of the Device Driver Table.
|
|
Ralf Corsepius <corsepiu@faw.uni-ulm.de> that adds initial Hitachi SH-2
support to RTEMS. Ralf's comments are:
Changes:
------
1. SH-Port:
* Many files renamed.
* CONSOLE_DEVNAME and MHZ defines removed from libcpu.
* console.c moved to libbsp/sh/shared, build in libbsp/sh/<BSP>/console
applying VPATH.
* CONSOLE_DEVNAME made BSP-specific, replacement is defined in bsp.h
* MHZ define replaced with HZ (extendent resolution) in custom/*.cfg
* -DHZ=HZ used in bspstart.c, only
* Makefile variable HZ used in bsp-dependent directories only.
2. SH1-Port
* clock-driver rewritten to provide better resolution for odd CPU
frequencies. This driver is only partially tested on hardware, ie.
sightly experimental, but I don't expect severe problems with it.
* Polling SCI-driver added. This driver is experimental and completly
untested yet. Therefore it is not yet used for the console (/dev/console
is still pointing to /dev/null, cf. gensh1/bsp.h).
* minor changes to the timer driver
* SH1 specific delay()/CPU_delay() now is implemented as a function
3. SH2-Port
* Merged
* IMO, the code is still in its infancy. Therefore I have interspersed
comments (FIXME) it for items which I think John should look after.
* sci and console drivers partially rewritten and extended (John, I hope
you don't mind).
* Copyright notices are not yet adapted
|
|
particular, using bsp.h, or getting information from the BSP which
should properly be obtained from RTEMS is forbidden. This is
necessary to strengthen the division between the BSP independent
parts of RTEMS and the BSPs themselves. This started after
comments and analysis by Ralf Corsepius <corsepiu@faw.uni-ulm.de>.
The changes primarily eliminated the need to include bsp.h and
peeking at BSP_Configuration. The use of Cpu_table in each
BSP needs to be eliminated.
|
|
Please find enclosed a patch which enables me to build the bare-bsp for
sh-rtems.
Changes:
1. Add preinstall to libbsp/bare/include/Makefile.in
2. Removed FORCEIT, add preinstall to
libbsp/sh/gensh1/include/Makefile.in
3. Disabled support of set_vector from sh code (shared/setvec.c is still
present but isn't used anymore), set_vector replaced with standard rtems
functions.
Problems still present:
1. Support of spin-delays in bare bsp
2. Proper support of cpu frequency
To configure I used:
<srcdir>/configure \
--target=sh-rtems \
--prefix=<instdir>/sh-bare \
--enable-bare-cpu-model=sh7032 \
--enable-bare-cpu-cflags='-Wall -m1 -DMHZ=20
-DCPU_CONSOLE_DEVNAME="\"/dev/null\""'
--enable-rtemsbsp=bare \
--disable-networking \
--disable-cxx \
--disable-posix \
--disable-tests
IMO, if there are no objections to this patch, a similar approach should
be applied to all CPUs/BSPs (esp. hppa1.1, mips64orion, ppc403, because
they apply set_vector inside of libcpu).
|
|
|
