| Commit message (Collapse) | Author | Files | Lines |
|---|
|
|
|
|
|
and not likely to become so. Comments on each configuration
are below.
+ Force CPU386 - This BSP was developed as part of the initial
port of RTEMS to the i386. This board has been unavailable
for a long time now.
+ GO32 - This BSP and some CPU code supported djgpp v1.x. This
version is now quite old. No one has stepped forward to
update the code to v2.x which may be technically impossible
anyway. More importantly, go32 has been superceded by the pc386 BSP.
|
|
.s files to .S in conformance with GNU conventions. This is a
minor step along the way to supporting automake.
|
|
and RPC support to RTEMS. Thanks. :) Email follows:
Hello,
For Xmas, here is the Remote Debugger on RTEMS !
Here are 2 patches for the Remote Debugger on RTEMS for pc386 from Linux
host :
- one for RTEMS it self,
- one for GDB-4.17.
1/ RTEMS patch
--------------
This patch adds 2 libraries :
- a simplified SUN RPC library
- the Remote Debugger library
The configuration command is the following :
../rtems4/configure --target=i386-rtemself --enable-rtemsbsp=pc386
--enable-rdbg
The SUN RPC library is built only if networking is set.
The RDBG library is built if networking and enable-rdbg are set.
The function used to initialize the debugger is :
rtems_rdbg_initialize ();
A special function has been created to force a task to be
in a "debug" state : enterRdbg().
The use of this function is not mandatory.
2/ GDB-4.17 patch
-----------------
This patch create a new RTEMS target for GDB-4.17.
The configuration command is the following :
./configure --enable-shared --target=i386RTEMS
To connect to a target, use :
target rtems [your_site_address]
Then, attach the target using : attach 1
And... Debug ;)
You can obtain the original GDB-4.17 on
ftp://ftp.debian.org/debian/dists/stable/main/source/devel/gdb_4.17.orig.tar.gz
This has been tested from a Debian 2.0.1 linux host.
|
|
Here is a patch that enables to catch exception
and get message before crashing RTEMS :)
It should be generic to any Intel port although enabled
only for pc386 BSP...
[Joel] I fixed the bug I introduced in irq_asm.s...
|
|
inline with the new IRQ structure.
|
|
Here is a enhanced version of my previous patch. This patch enables
to potentially share the new interrupt management code for all Intel targets
(pc386, go32 and force386) bsp.
Note : this patch is complete only for pc386. It still needs to
be completed for go32 and force386. I carrefully checked
that anything needed is in for force386 (only some function
name changes for IDT manipulation and GDT segment
manipulation). But anyway I will not be able to test any
of theses targets...
|
|
|
|
.align between i386-rtems (real number on .align) and i386-go32-rtems
(power of 2).
|
|
|
|
of switching to the modified GNU GPL.
|
|
|
