2006-08-23 Joel Sherrill <joel@OARcorp.com>

	* Makefile.am, configure.ac, FAQ/stamp-vti, FAQ/version.texi,
	common/cpright.texi: Merging CPU Supplements into a single document.
	As part of this removed the obsolete and impossible to maintain size
	and timing information.
	* cpu_supplement/.cvsignore, cpu_supplement/Makefile.am,
	cpu_supplement/arm.t, cpu_supplement/i386.t, cpu_supplement/m68k.t,
	cpu_supplement/mips.t, cpu_supplement/powerpc.t,
	cpu_supplement/preface.texi, cpu_supplement/sh.t,
	cpu_supplement/sparc.t, cpu_supplement/tic4x.t: New files.
	* supplements/.cvsignore, supplements/Makefile.am,
	supplements/supplement.am, supplements/arm/.cvsignore,
	supplements/arm/BSP_TIMES, supplements/arm/ChangeLog,
	supplements/arm/Makefile.am, supplements/arm/arm.texi,
	supplements/arm/bsp.t, supplements/arm/callconv.t,
	supplements/arm/cpumodel.t, supplements/arm/cputable.t,
	supplements/arm/fatalerr.t, supplements/arm/intr_NOTIMES.t,
	supplements/arm/memmodel.t, supplements/arm/preface.texi,
	supplements/arm/timeBSP.t, supplements/c4x/.cvsignore,
	supplements/c4x/BSP_TIMES, supplements/c4x/ChangeLog,
	supplements/c4x/Makefile.am, supplements/c4x/bsp.t,
	supplements/c4x/c4x.texi, supplements/c4x/callconv.t,
	supplements/c4x/cpumodel.t, supplements/c4x/cputable.t,
	supplements/c4x/fatalerr.t, supplements/c4x/intr_NOTIMES.t,
	supplements/c4x/memmodel.t, supplements/c4x/preface.texi,
	supplements/c4x/timeBSP.t, supplements/i386/.cvsignore,
	supplements/i386/ChangeLog, supplements/i386/FORCE386_TIMES,
	supplements/i386/Makefile.am, supplements/i386/bsp.t,
	supplements/i386/callconv.t, supplements/i386/cpumodel.t,
	supplements/i386/cputable.t, supplements/i386/fatalerr.t,
	supplements/i386/i386.texi, supplements/i386/intr_NOTIMES.t,
	supplements/i386/memmodel.t, supplements/i386/preface.texi,
	supplements/i386/timeFORCE386.t, supplements/m68k/.cvsignore,
	supplements/m68k/ChangeLog, supplements/m68k/MVME136_TIMES,
	supplements/m68k/Makefile.am, supplements/m68k/bsp.t,
	supplements/m68k/callconv.t, supplements/m68k/cpumodel.t,
	supplements/m68k/cputable.t, supplements/m68k/fatalerr.t,
	supplements/m68k/intr_NOTIMES.t, supplements/m68k/m68k.texi,
	supplements/m68k/memmodel.t, supplements/m68k/preface.texi,
	supplements/m68k/timeMVME136.t, supplements/m68k/timedata.t,
	supplements/mips/.cvsignore, supplements/mips/BSP_TIMES,
	supplements/mips/ChangeLog, supplements/mips/Makefile.am,
	supplements/mips/bsp.t, supplements/mips/callconv.t,
	supplements/mips/cpumodel.t, supplements/mips/cputable.t,
	supplements/mips/fatalerr.t, supplements/mips/intr_NOTIMES.t,
	supplements/mips/memmodel.t, supplements/mips/mips.texi,
	supplements/mips/preface.texi, supplements/mips/timeBSP.t,
	supplements/powerpc/.cvsignore, supplements/powerpc/ChangeLog,
	supplements/powerpc/DMV177_TIMES, supplements/powerpc/Makefile.am,
	supplements/powerpc/PSIM_TIMES, supplements/powerpc/bsp.t,
	supplements/powerpc/callconv.t, supplements/powerpc/cpumodel.t,
	supplements/powerpc/cputable.t, supplements/powerpc/fatalerr.t,
	supplements/powerpc/intr_NOTIMES.t, supplements/powerpc/memmodel.t,
	supplements/powerpc/powerpc.texi, supplements/powerpc/preface.texi,
	supplements/powerpc/timeDMV177.t, supplements/powerpc/timePSIM.t,
	supplements/sh/.cvsignore, supplements/sh/BSP_TIMES,
	supplements/sh/ChangeLog, supplements/sh/Makefile.am,
	supplements/sh/bsp.t, supplements/sh/callconv.t,
	supplements/sh/cpumodel.t, supplements/sh/cputable.t,
	supplements/sh/fatalerr.t, supplements/sh/intr_NOTIMES.t,
	supplements/sh/memmodel.t, supplements/sh/preface.texi,
	supplements/sh/sh.texi, supplements/sh/timeBSP.t,
	supplements/sparc/.cvsignore, supplements/sparc/ChangeLog,
	supplements/sparc/ERC32_TIMES, supplements/sparc/Makefile.am,
	supplements/sparc/bsp.t, supplements/sparc/callconv.t,
	supplements/sparc/cpumodel.t, supplements/sparc/cputable.t,
	supplements/sparc/fatalerr.t, supplements/sparc/intr_NOTIMES.t,
	supplements/sparc/memmodel.t, supplements/sparc/preface.texi,
	supplements/sparc/sparc.texi, supplements/sparc/timeERC32.t,
	supplements/template/.cvsignore, supplements/template/BSP_TIMES,
	supplements/template/ChangeLog, supplements/template/Makefile.am,
	supplements/template/bsp.t, supplements/template/callconv.t,
	supplements/template/cpumodel.t, supplements/template/cputable.t,
	supplements/template/fatalerr.t, supplements/template/intr_NOTIMES.t,
	supplements/template/memmodel.t, supplements/template/preface.texi,
	supplements/template/template.texi, supplements/template/timeBSP.t: Removed.

1 files changed, 0 insertions, 112 deletions

diff --git a/doc/supplements/template/timeBSP.t b/doc/supplements/template/timeBSP.t
deleted file mode 100644
index 85e5ea44aa..0000000000
--- a/doc/supplements/template/timeBSP.t
+++ /dev/null
@@ -1,112 +0,0 @@
-@c
-@c  COPYRIGHT (c) 1988-2002.
-@c  On-Line Applications Research Corporation (OAR).
-@c  All rights reserved.
-@c
-@c  $Id$
-@c
-
-@include common/timemac.texi
-@tex
-\global\advance \smallskipamount by -4pt
-@end tex
-
-@chapter MYBSP Timing Data
-
-@section Introduction
-
-The timing data for the XXX version of RTEMS is
-provided along with the target dependent aspects concerning the
-gathering of the timing data.  The hardware platform used to
-gather the times is described to give the reader a better
-understanding of each directive time provided.  Also, provided
-is a description of the interrupt latency and the context switch
-times as they pertain to the XXX version of RTEMS.
-
-@section Hardware Platform
-
-All times reported except for the maximum period
-interrupts are disabled by RTEMS were measured using a Motorola
-MYBSP CPU board.  The MYBSP is a RTEMS_MAXIMUM_DISABLE_PERIOD_MHZ
-Mhz board with one wait
-state dynamic memory and a XXX numeric coprocessor.  The
-Zilog 8036 countdown timer on this board was used to measure
-elapsed time with a one-half microsecond resolution.  All
-sources of hardware interrupts were disabled, although the
-interrupt level of the processor allows all interrupts.
-
-The maximum period interrupts are disabled was
-measured by summing the number of CPU cycles required by each
-assembly language instruction executed while interrupts were
-disabled.  The worst case times of the XXX microprocessor
-were used for each instruction.  Zero wait state memory was
-assumed.  The total CPU cycles executed with interrupts
-disabled, including the instructions to disable and enable
-interrupts, was divided by 20 to simulate a RTEMS_MAXIMUM_DISABLE_PERIOD_MHZ
-Mhz processor.  It
-should be noted that the worst case instruction times for the
-processor assume that the internal cache is disabled and that no
-instructions overlap.
-
-@section Interrupt Latency
-
-The maximum period with interrupts disabled within
-RTEMS is less than RTEMS_MAXIMUM_DISABLE_PERIOD 
-microseconds including the instructions
-which disable and re-enable interrupts.  The time required for
-the processor to vector an interrupt and for the RTEMS entry
-overhead before invoking the user's interrupt handler are a
-total of RTEMS_INTR_ENTRY_RETURNS_TO_PREEMPTING_TASK 
-microseconds.  These combine to yield a worst case
-interrupt latency of less than 
-RTEMS_MAXIMUM_DISABLE_PERIOD + RTEMS_INTR_ENTRY_RETURNS_TO_PREEMPTING_TASK 
-microseconds at RTEMS_MAXIMUM_DISABLE_PERIOD_MHZ
-Mhz.  [NOTE:  The maximum period with interrupts
-disabled was last determined for Release 
-RTEMS_RELEASE_FOR_MAXIMUM_DISABLE_PERIOD.]
-
-It should be noted again that the maximum period with
-interrupts disabled within RTEMS is hand-timed and based upon
-worst case (i.e. CPU cache disabled and no instruction overlap)
-times for a RTEMS_MAXIMUM_DISABLE_PERIOD_MHZ
-Mhz processor.  The interrupt vector and entry
-overhead time was generated on an MYBSP benchmark platform
-using the Multiprocessing Communications registers to generate
-as the interrupt source.
-
-@section Context Switch
-
-The RTEMS processor context switch time is RTEMS_NO_FP_CONTEXTS
-microseconds on the MYBSP benchmark platform when no floating
-point context is saved or restored.  Additional execution time
-is required when a TASK_SWITCH user extension is configured.
-The use of the TASK_SWITCH extension is application dependent.
-Thus, its execution time is not considered part of the raw
-context switch time.
-
-Since RTEMS was designed specifically for embedded
-missile applications which are floating point intensive, the
-executive is optimized to avoid unnecessarily saving and
-restoring the state of the numeric coprocessor.  The state of
-the numeric coprocessor is only saved when an FLOATING_POINT
-task is dispatched and that task was not the last task to
-utilize the coprocessor.  In a system with only one
-FLOATING_POINT task, the state of the numeric coprocessor will
-never be saved or restored.  When the first FLOATING_POINT task
-is dispatched, RTEMS does not need to save the current state of
-the numeric coprocessor.
-
-The exact amount of time required to save and restore
-floating point context is dependent on whether an XXX or
-XXX is being used as well as the state of the numeric
-coprocessor.  These numeric coprocessors define three operating
-states: initialized, idle, and busy.  RTEMS places the
-coprocessor in the initialized state when a task is started or
-restarted.  Once the task has utilized the coprocessor, it is in
-the idle state when floating point instructions are not
-executing and the busy state when floating point instructions
-are executing.  The state of the coprocessor is task specific.
-
-The following table summarizes the context switch
-times for the MYBSP benchmark platform:
-