diff options
Diffstat (limited to '')
| -rw-r--r-- | user/bsps/arm/raspberrypi.rst | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/user/bsps/arm/raspberrypi.rst b/user/bsps/arm/raspberrypi.rst index 235134f..8f40e92 100644 --- a/user/bsps/arm/raspberrypi.rst +++ b/user/bsps/arm/raspberrypi.rst @@ -12,7 +12,7 @@ The default bootloader on the Raspberry Pi which is used to boot Raspbian or other OS can be also used to boot RTEMS. U-boot can also be used. Setup SD card ----------------- +------------- The Raspberry Pis have an unconventional booting mechanism. The GPU boots first, initializes itself, runs the bootloader and starts the CPU. @@ -20,13 +20,13 @@ The bootloader looks for a kernel image, by default the kernel images must have a name of the form ``kernel*.img`` but this can be changed by adding `kernel=<img_name>` to ``config.txt``. -You must provide the required firmware files on the SD card for the GPU to proceed, -and thereby to boot RTEMS. -The BSP currently boots up with an older version of the official firmware. These files -can be downloaded from -`the Raspberry Pi Firmware Repository <https://github.com/raspberrypi/firmware/tree/1.20200601/boot>`_. -You can remove the ``kernel*.img`` files if you want to, but don't touch -the other files. +You must provide the required firmware files on the SD card for the GPU to +proceed, and thereby to boot RTEMS. The BSP currently boots up with an older +version of the official firmware. These files can be downloaded from `the +Raspberry Pi Firmware Repository +<https://github.com/raspberrypi/firmware/tree/1.20200601/boot>`_. You can +remove the ``kernel*.img`` files if you want to, but don't touch the other +files. Copy these files in to a SD card with FAT filesystem. @@ -41,7 +41,7 @@ To create the kernel image: .. code-block:: none - $ arm-rtems5-objcopy -Obinary hello.exe kernel.img + $ xsarm-rtems@rtems-ver-major@-objcopy -Obinary hello.exe kernel.img Copy the kernel image to the SD card. @@ -54,7 +54,7 @@ Make sure you have these lines below, in your ``config.txt``. kernel=kernel.img SPI Driver ------------- +---------- SPI drivers are registered by the ``rpi_spi_init(bool bidirectional_mode)`` function. @@ -72,7 +72,7 @@ SPI drivers are registered by the ``rpi_spi_init(bool bidirectional_mode)`` func } I2C Driver ------------- +---------- I2C drivers are registered by the ``rpi_setup_i2c_bus()`` function. @@ -132,7 +132,7 @@ In a new terminal, run GDB using .. code-block:: none - $ arm-rtems5-gdb hello.exe + $ arm-rtems@rtems-ver-major@-gdb hello.exe This will open GDB and will load the symbol table from hello.exe. Issue the following commands in the GDB prompt. |